Katonah Medic
New Member
Just replaced all appliances in the kitchen, and when installing a new under-the-counter dishwasher, the two tabs that secure the machine to the underside of the countertop does not line up to the old holes. This means I have to drill new holes to be able to use screws to secure the washer to the countertop.
My tops are granite.
Should/can I use a masonry bit to make pilot holes? I've seen granite cut with special wet blades.
Do I need to keep the bit wet?
Are there any special granite anchors? The old ones appear glued in.
Thanks.
My tops are granite.
Should/can I use a masonry bit to make pilot holes? I've seen granite cut with special wet blades.
Do I need to keep the bit wet?
Are there any special granite anchors? The old ones appear glued in.
Thanks.