pmetiv
New Member
This is my first post on this forum but have been reading it for a few years. Lots of good advices on here! Thanks!
I want to install a valve trim (Grohe: 19 494 000) which as the diverter at the valve trim instead of at the spout. Is this a bad choice?
We have very good water pressure in the appartment we live in. I saw a few post about strong water pressure being an issues some time with those.
It also looks like 90% of the diverters are at the spout. Is it only because it's cheaper to make?
Thanks for any advice/ experience you might have?
Pierre
I want to install a valve trim (Grohe: 19 494 000) which as the diverter at the valve trim instead of at the spout. Is this a bad choice?
We have very good water pressure in the appartment we live in. I saw a few post about strong water pressure being an issues some time with those.
It also looks like 90% of the diverters are at the spout. Is it only because it's cheaper to make?
Thanks for any advice/ experience you might have?
Pierre
Last edited: