zoomzoom3
New Member
- Messages
- 5
- Reaction score
- 0
- Points
- 0
I went from a 34" X 48" pan to a smaller 32" X 48" pan. By doing this I just realized that my shower handles are way off now. I also was planning on switching from a two handle to a single handle moen valve.
(The left handle is actually where the center of the shower/valve should be)
1) How would I move the supply lines and valve to work with the new pan.
2) Can I just use two 45 degree fittings to move the left supply line to the left about 4-6" and then just leave the right supply line alone.
3) Does it matter how high I start the 45's.
Any other suggestions.
Thanks in advance,
dan
(The left handle is actually where the center of the shower/valve should be)
1) How would I move the supply lines and valve to work with the new pan.
2) Can I just use two 45 degree fittings to move the left supply line to the left about 4-6" and then just leave the right supply line alone.
3) Does it matter how high I start the 45's.
Any other suggestions.
Thanks in advance,
dan