CompletelyHis
New Member
- Messages
- 19
- Reaction score
- 0
- Points
- 0
I have a jacuzzi brand tub that is about 13 years old. It has 4 jets, 2 on each side. The ports for the jets seem to be level, at best, perhaps even angled up in such a way as to cause water to remain at the bottom of the port, just under the jet. this creates a funk, which is not desirable at all! Ideally I'd like to replace the ports with some that will actually drain water out of them when we drain the water. the other option would be to build up the bottom, so that it would drain, using some sort of epoxy compound or something.
any ideas?
any ideas?