i'm looking to supply a 20 gal hw tank (laars endurance boiler) with 3/4" line for 2 floor 2 full bath unit. then i guess i'll run 3/4" line out too. but recently was wondering if i shouldn't go with 1/2" instead, thinking tap and shower might warm up quicker.
current connects to tank ar 1/2" but step up to 3/4" to enter the actual unit. i'm worried about adequate flow, etc. the hw part of this boiler has not been in use as of yet.
any thoughts and advice much appreciated
current connects to tank ar 1/2" but step up to 3/4" to enter the actual unit. i'm worried about adequate flow, etc. the hw part of this boiler has not been in use as of yet.
any thoughts and advice much appreciated