nascar fan
New Member
- Messages
- 2
- Reaction score
- 0
- Points
- 0
Hello, i have a problem i need help with. I'm having a pump issue. I pulled my well pump, cleaned it and turned it on with just the pump in the water and it pumped fine. I put all the pvc pipe back on it, about 50 feet down and turned it back on and nothing. I noticed that the wires are put together in one spot with wire nuts. They are under water, will this cause a problem? I'm lost, i'm not a plumber at all.
Also does any one know how deep a 1/2 h.p. jet pump will pull? I have one that i was going to replace the submersable pump with but not sure if it will work as well or not. I'm guessing my well in around 50 to 70 feet deep and the house is about 30 yards from the well. Is this a good idea or a waste of time?
Also does any one know how deep a 1/2 h.p. jet pump will pull? I have one that i was going to replace the submersable pump with but not sure if it will work as well or not. I'm guessing my well in around 50 to 70 feet deep and the house is about 30 yards from the well. Is this a good idea or a waste of time?