One of those "Oh Drat" situations:
The flange is in the wall, basically an ABS end piece, and is not flush with the wall. Can't reach anything so I can't run a new piece. It's flush on the left side but recessed about 1/8" into the wall on the right. That's too much for those rather thin Zurn Neo-Seal neoprene gaskets. What can be done?
Can I "thicken up" the flange rim a bit, somehow? Or apply something onto the back of the toilet? Or slice one of those (expensive...) Neo-Seal rings and use it to stack a sliver onto another complete Neo-Seal ring.
Regards, Joerg.
The flange is in the wall, basically an ABS end piece, and is not flush with the wall. Can't reach anything so I can't run a new piece. It's flush on the left side but recessed about 1/8" into the wall on the right. That's too much for those rather thin Zurn Neo-Seal neoprene gaskets. What can be done?
Can I "thicken up" the flange rim a bit, somehow? Or apply something onto the back of the toilet? Or slice one of those (expensive...) Neo-Seal rings and use it to stack a sliver onto another complete Neo-Seal ring.
Regards, Joerg.