Hi there,
Love the site, very helpful.
I have a new Vespin II with 14" rough replacing a Briggs unit. The water supply is about 4.5 inches off center, if that. It has a full knob on it, nothing fancy from the wall. Should I use a 12" rough and 90 elbow joint with a quarter-turn Dahl valve or get a qualified plumber to move the supply over to the left so I can use the proper 14" rough? Legroom is not an issue but I don't want the toilet too close to the tub, and I know the 14" rough is correct and I already bought the 14" Unifit adaptor.
Floor is just linoleum, nothing fancy.
Ideas?
Thank you
Pod
Love the site, very helpful.
I have a new Vespin II with 14" rough replacing a Briggs unit. The water supply is about 4.5 inches off center, if that. It has a full knob on it, nothing fancy from the wall. Should I use a 12" rough and 90 elbow joint with a quarter-turn Dahl valve or get a qualified plumber to move the supply over to the left so I can use the proper 14" rough? Legroom is not an issue but I don't want the toilet too close to the tub, and I know the 14" rough is correct and I already bought the 14" Unifit adaptor.
Floor is just linoleum, nothing fancy.
Ideas?
Thank you
Pod
Last edited by a moderator: