mightybhwk
New Member
- Messages
- 3
- Reaction score
- 0
- Points
- 0
Hi,
I'm installing a sewage pump basin into an original utility/washer sump pump hole. I have another sump pump for the rain water. My question is when I was cleaning out the hole I noticed that table water came back in. Could I drill small holes in the bottom of the basin to allow table water to enter? Or will the rain water sump handle this? This is for a basement bathroom install.
Also, is there a way to cut cast iron without a snapper? My floor drain is cast and I wanted it to tie into the new pvc drain.
Thanks,
Randy
I'm installing a sewage pump basin into an original utility/washer sump pump hole. I have another sump pump for the rain water. My question is when I was cleaning out the hole I noticed that table water came back in. Could I drill small holes in the bottom of the basin to allow table water to enter? Or will the rain water sump handle this? This is for a basement bathroom install.
Also, is there a way to cut cast iron without a snapper? My floor drain is cast and I wanted it to tie into the new pvc drain.
Thanks,
Randy