L
lucy
Guest
I've been trying to research just what goes on in a rough inspection (this is my first). Water seems to be pretty straighforward. But I need some basic advice about the DWV.
What I understand is that all of the DWV everthing needs to be sealed in some way and 5 pounds of air pressure introduced. Can somebody tell me the RIGHT way to seal the following:
A. 2-inch ABS vent risers out my roof?
B. ABS toilet flange and 1 installed operating toilet.
C. ABS SanT openings for 3 lav sinks
D. 2 bowl kitchen sink (installed) with disposal and strainer basket (not a real stopper)
E. Utility sink (installed)
F. ABS 2 part (mud) shower drain
G. ABS tub drain with overflow
Should I assume this should be sealed and pressurized before the inspector arrives? Besides having the water and the gas on...is there anything else that I need to do?
Thanks - please be as specific as you can!
Lucy
What I understand is that all of the DWV everthing needs to be sealed in some way and 5 pounds of air pressure introduced. Can somebody tell me the RIGHT way to seal the following:
A. 2-inch ABS vent risers out my roof?
B. ABS toilet flange and 1 installed operating toilet.
C. ABS SanT openings for 3 lav sinks
D. 2 bowl kitchen sink (installed) with disposal and strainer basket (not a real stopper)
E. Utility sink (installed)
F. ABS 2 part (mud) shower drain
G. ABS tub drain with overflow
Should I assume this should be sealed and pressurized before the inspector arrives? Besides having the water and the gas on...is there anything else that I need to do?
Thanks - please be as specific as you can!
Lucy