I have a deep well jet pump (Myers HR50D) that I just replaced. I hooked everything up and it worked great until it reaches the cutoff pressure and the switch opened. Now the switch is stuck in the open position and I can’t figure out why or how to get it to close again. It’s a typical 2 post pressure switch.
I checked the old pump that I took out and on the pressure switch (also 2 post) the default position is closed with the contacts touching. You can manually open the switch but it springs right back to closed when you let go. This new pump is stuck in the open position.
Is the presssure switch faulty or does it have some sort of low pressure override that’s not letting the switch close?
I checked the old pump that I took out and on the pressure switch (also 2 post) the default position is closed with the contacts touching. You can manually open the switch but it springs right back to closed when you let go. This new pump is stuck in the open position.
Is the presssure switch faulty or does it have some sort of low pressure override that’s not letting the switch close?