Tyler van Staalduinen
New Member
H
I am trying to install a burcam shallow well pump to pull water out of a holding tank.
I got a new pressure tank and pump.
When I plug in the pump it starts up and builds pressure to 50 psi, it then begins to rapidly and violently switch on and off until there is not enough pressure and starts to rebuild pressure again.
I have tried moving the pressure line out of the motor closer to the tank.
I have also taken apart and made sure all the lines are clear.
I am at a loss and can't figure out what I'm doing wrong.
I am trying to install a burcam shallow well pump to pull water out of a holding tank.
I got a new pressure tank and pump.
When I plug in the pump it starts up and builds pressure to 50 psi, it then begins to rapidly and violently switch on and off until there is not enough pressure and starts to rebuild pressure again.
I have tried moving the pressure line out of the motor closer to the tank.
I have also taken apart and made sure all the lines are clear.
I am at a loss and can't figure out what I'm doing wrong.