I am not getting any brine draw from my brine tank. For troubleshooting, I eliminated the brine tank and its valves by putting the 2 ft brine line into a bucket of water. When I do a regeneration, there is no suction during any of the cycles and in fact there is water coming into the bucket when it should be coming out. Water does come out when it should. Putting my finger over the end of the tube I feel no suction or perhaps a very tiny amount. Things I have tried:
Removed drain line and poured water down it.
Replaced the injector.
Replaced the O rings on the brine line elbow fitting and the drain line fitting.
Checked for air leaks.
Motor is turning.
Ordered (but not received) spacer stack and pistons.
Any ideas?
Removed drain line and poured water down it.
Replaced the injector.
Replaced the O rings on the brine line elbow fitting and the drain line fitting.
Checked for air leaks.
Motor is turning.
Ordered (but not received) spacer stack and pistons.
Any ideas?