Kohler Transfer Valve - KOHLER 728-K-NA Issue

[PumpNewb1]

Hi All -

Doing a small bathroom remodel and using a transfer valve to control a separate wand. Everything is hooked up and working except for the transfer valve. I am positive that water is reaching the transfer valve but no matter which way i turn the handle only a trickle of water will come out which takes a long time to get too. There is like 0 pressure.

Side Note, I followed the instructions and converted it to a 2-way transfer valve. I took out the inner nut and followed instructions with the clip on the front.

Any ideas? Want to figure out before closing wall of course.

 

[Fitter30]

Check this Push the detent down; ensure the points of the detent engage the
notches of the valve cartridge

 

[Sponsor]

 

[Breplum]

Note: Drywall screws are quite inadequate for securing fixtures.

 

[PumpNewb1]

Check this Push the detent down; ensure the points of the detent engage the
notches of the valve cartridge

This was it ! Thanks

 

[PumpNewb1]

Note: Drywall screws are quite inadequate for securing fixtures.

Switching them out - thanks for heads up