GaryG
New Member
Hi,
I have a Kinetico Model 60, which stopped drawing brine. During the brine cycle, water continues to flow to the brine tank (no suction). It won't drwa on either the normal timer or the manual regeneration.
Here is what I have done already:
1. disconnected brine line (confirmed there is no suction, but rather water flow from the head)
2. blew out drain line (it was not plugged)
3. Took Head apart
.... confirmed gears and turbine spin freely
.... blew air through the venturi and all the openings
.... verified all the valves move freely
.... confirmed check valves are in place.
Any ideas on what to try next?
I have a Kinetico Model 60, which stopped drawing brine. During the brine cycle, water continues to flow to the brine tank (no suction). It won't drwa on either the normal timer or the manual regeneration.
Here is what I have done already:
1. disconnected brine line (confirmed there is no suction, but rather water flow from the head)
2. blew out drain line (it was not plugged)
3. Took Head apart
.... confirmed gears and turbine spin freely
.... blew air through the venturi and all the openings
.... verified all the valves move freely
.... confirmed check valves are in place.
Any ideas on what to try next?