I'm installing a washer and dryer in my bathroom during a complete remodel of the bathroom. I'm planning on tying into the bath tub drain and installing a trap in the back wall of the bathroom for the washer. It will be about 2-3 feet above the floor and uses 2 inch ABS. The Y is going to be placed after the tub drain trap. Is this the proper way to do this?
The tub drain links up to a larger ABS pipe heading into the basement and another heading off to (I'm assuming) the sink.
Code:
Here's a rough diagram
Washer drain tube
|
|
|
Trap for washer
|
|
| -------------------------|
|
Tub Y for overflow and drain---Tub Trap------Y for washer----
The tub drain links up to a larger ABS pipe heading into the basement and another heading off to (I'm assuming) the sink.
Last edited: