JohnfrWhipple
BATHROOM DESIGN & BUILD
It's only one block out of the eight.
The very first one I installed. Can I fix it with Kerdi Board or Kerdi Fix? lol
I doubt it is the heat since the LED's are installed on a 6" Heat sink and the LED is only 3 lights.
I need to go back and find the first few pictures - I think the first LED was an old light that had been around the shop for a while.
The light seems to be trying to do something. It appears to have Red Green Blue. But it appears to be cycling through the colours a hair slower and has no where near the output.
I'm going to push forward and run a spare set of wire so I can fix it down the road.
On one project I had a LED light go wacky and I just left it. Two weeks later it self corrected. I'm hoping it is a little moisture cause some kind of voltage transfer across the solder connections.
I'll give it a month and then make the change later.
Nothing a Scotch and a Angle Grinder and Diamond Blade can't get too.
I doubt it is the heat since the LED's are installed on a 6" Heat sink and the LED is only 3 lights.
I need to go back and find the first few pictures - I think the first LED was an old light that had been around the shop for a while.
The light seems to be trying to do something. It appears to have Red Green Blue. But it appears to be cycling through the colours a hair slower and has no where near the output.
I'm going to push forward and run a spare set of wire so I can fix it down the road.
On one project I had a LED light go wacky and I just left it. Two weeks later it self corrected. I'm hoping it is a little moisture cause some kind of voltage transfer across the solder connections.
I'll give it a month and then make the change later.
Nothing a Scotch and a Angle Grinder and Diamond Blade can't get too.
Last edited by a moderator: