FreeLander
Member
Hello,
I did my research on making my own USBC, I figured that I needed two 5.1kOhms resistors from CC1,CC2 to GND. I managed to find the pathway of CC1 in the breakout board I'm using and used the resistor to pull it down to GND. It did work and charged my Hawai headset, but it does not charge my Mac, I connected it to a PD trigger board and it only shows 5v. Any input is appreciated. Thanks.
I did my research on making my own USBC, I figured that I needed two 5.1kOhms resistors from CC1,CC2 to GND. I managed to find the pathway of CC1 in the breakout board I'm using and used the resistor to pull it down to GND. It did work and charged my Hawai headset, but it does not charge my Mac, I connected it to a PD trigger board and it only shows 5v. Any input is appreciated. Thanks.