NickGriffith
New Member
Hello,
I'm trying to install this closet flange:
There is a 90 degree elbow just below the concrete so my flange bottoms out when I try to push it down into the drain pipe:
The outer layer of the 2 visible PVC layers above the 90 is a coupler.
Can I trim a couple inches from the bottom of the flange?
Is there anything I can do besides breaking up the concrete? There's only about 3/4" of the stub above the concrete.
In addition, the concrete is "mounded up" a bit around the stub and not level. How can I level this out so my flange sits flat on the concrete?
Here are some more photos:
Thanks all!
I'm trying to install this closet flange:
There is a 90 degree elbow just below the concrete so my flange bottoms out when I try to push it down into the drain pipe:
The outer layer of the 2 visible PVC layers above the 90 is a coupler.
Can I trim a couple inches from the bottom of the flange?
Is there anything I can do besides breaking up the concrete? There's only about 3/4" of the stub above the concrete.
In addition, the concrete is "mounded up" a bit around the stub and not level. How can I level this out so my flange sits flat on the concrete?
Here are some more photos:
Thanks all!