Ron1969
New Member
Team,
I have replaced the circuit board on my Clack WS-1 valve and it is working again.
I have left it on factory settings and regenerate a few times. The toiletbowls are not brown anymore thats a good start.
I have bought and installed the system from this forum years ago through Gary?
I am on a shallow well with above ground 1HP pump.
I have purchased test strips and tested water.
The water straight out of well is hard, around 50-100ppm.
I have around the same reading from faucet.
Iron looks minimal and the only other high reading is total alkalinity
I will attach test strip results with bottle.
Needles to say it needs more adjustments in the valve.
What more information is needed for you gents to assist me with the settings?
Any help gretly appreciated.
Ron
I have replaced the circuit board on my Clack WS-1 valve and it is working again.
I have left it on factory settings and regenerate a few times. The toiletbowls are not brown anymore thats a good start.
I have bought and installed the system from this forum years ago through Gary?
I am on a shallow well with above ground 1HP pump.
I have purchased test strips and tested water.
The water straight out of well is hard, around 50-100ppm.
I have around the same reading from faucet.
Iron looks minimal and the only other high reading is total alkalinity
I will attach test strip results with bottle.
Needles to say it needs more adjustments in the valve.
What more information is needed for you gents to assist me with the settings?
Any help gretly appreciated.
Ron