I’ve got some tight areas that I need to replace angle stops on my PEX stubouts. I have tools for crimping but unless I remove the entire vanity I can’t fit the crimpers in the area to get a GOOD even crimp.
Wild you guys hesitate to use stainless cinch clamps instead? I can fit the tool in there without issue. Are they reliable with correct tool and calibrated correctly?
other option is a push to connect.
I’ve researched and results were mixed with most info coming from a decade ago. I know a lots changed.
photo attached for reference.
Wild you guys hesitate to use stainless cinch clamps instead? I can fit the tool in there without issue. Are they reliable with correct tool and calibrated correctly?
other option is a push to connect.
I’ve researched and results were mixed with most info coming from a decade ago. I know a lots changed.
photo attached for reference.
Last edited by a moderator: