Royerm
Member
Hi Folks...
As I'm preparing for a new shower install in the basement I decided
to bring the acrylic base from the garage to see approximately where
the drain would end-up etc etc etc....
It was standing up right in the cardboard in the garage and
when I put it on the floor I noticed it was curved a bit on both axes,
the middle being the most protruded on the 4 sides.
I'm keeping it inside for the night to see if it will straighten-up..
Any comments???? is this normal???
Regards
As I'm preparing for a new shower install in the basement I decided
to bring the acrylic base from the garage to see approximately where
the drain would end-up etc etc etc....
It was standing up right in the cardboard in the garage and
when I put it on the floor I noticed it was curved a bit on both axes,
the middle being the most protruded on the 4 sides.
I'm keeping it inside for the night to see if it will straighten-up..
Any comments???? is this normal???
Regards