drain

  1. Sacman

    Drain question and whole house filter questions

    Need help in figuring out a drain for a water softener that I would like to have a plumber install in a new home being built. I have a loop for a water filter (along with a 20amp electrical) that will be installed. The whole house water filter is a Aquasana (model EQ-AST-WH) that I chose just...
  2. Nizolekz

    Dual Sink Issue

    Hey All - I was hoping you could help me with an issue that I’m having and can’t figure out what might be causing it. I have side by side sinks, one with a garbage disposal and the other is a standard drain. When I have stuff in the disposal along with some water (usually to help the...
  3. Wake_999

    Sink Drain Leaking - Compression fitting slipping

    Hi, I have a bathroom sink that is leaking. The issue is the compression fitting (see picture attached). I tighten it as much as I dare, but over time, the compression fitting slips (due to the weight of the p-trap ) and then it start leaking. I have addressed this temporarily by supporting the...
  4. Kevin121

    Re-route washing machine drain - vent question

    Hello - I am looking to re-route my washing machine's drain line from the main septic drain to a separate drain/location. The question I have is regarding the vent for my toilet that is the next fixute "downstream" of the existing washing machine drain. The attached pictures probably illustrate...
  5. Tspunk

    Help with water softener installation with no drain nearby

    Hello, I've had so much trouble these past 2 months trying to figure out what to do about my water softener. I've had hard water since I moved in and finally decided to buy a Whirlpool WHESFC water softener a couple months ago. I thought it would be quite simple for a plumber to install it...
  6. BryceinSLC

    High Loop Drain that Goes Below Trap

    Hello All... First post of this forum, here we go! My dishwasher's drain line has a high loop... but.. after the loop it goes down to below the sink trap and back up to the disposal. (actually its goes slightly above the disposal, then back down to the disposal, so 2 high loops?) Is this ok? I...
  7. Scott Moorman

    Adding island sink drain line

    OK - moving my sink to an island. The closest drain pipe is the downstairs bathroom closet flange (to the right) and main stack (to the left). The new sink is pretty much 12FT to the right of the closet flange. I might be redoing the bathroom floor (based on the staining around the flange)...
  8. TryingToPlumb

    Help with a "builder" basement shower drain rough in

    Hey all, happy holidays. I am finishing the basement and the builder "roughed" in some stuff for a bathroom down there. Ive completed the toilet, vanity and shower water supply lines. Looking at where the shower drain is, its off center. Im not sure what to do with it or what I am really...
  9. s00316

    Water softener and Neutralizer Drain Problem

    I have water softener and neutralizer on basement but I do not have any floor drain or access to main drain. (I mean I am sure it is in somewhere under slab but that would cost me too much to dig out the floor, etc.) Sump pit and pump is not an option for me. For now, previous owner, connected...
  10. Roadman33

    Rough in drain cluster#@**!help

    hi guys, I pulled a permit to make my basement bath up to code and need some help. yellow line: 2" goes down to slab then into 3". (think this is vent for toilet?) pink line: 2" goes in to mechanical room p trap for hot water heater overflow & furnace cond. drain. drains down into slab...
  11. Spaceoy_psy

    Bath drain plate won't come off... Or screw back down

    Got myself into a plumbing pickle, right at the first hurdle. We have a funky smell coming out the bath drain. Despite knowing little about plumbing, I figured removing the drain cover would be a good place to start, get a better view down into the P-Trap etc. But the screw just keeps spinning...
  12. Dallan

    Sink addition to Laundry room

    My wife would like a sink added to our Laundry room. I'm pretty short on spacing to put a 1.5" sanitary tee above the 2" sanitary tee and go around the 2" washing machine drain and keep the proper angle for drainage. is it possible to raise the 2" sanitary tee up and place a 1.5" x 2" x 2"...
  13. Tiffany Herndon

    How to convert a "no hole" tub overflow drain to a 1 or 2 hole

    Hello, I need some help with my bathtub situation. I just bought this house, and I have never seen an overflow drain like this before.. I'm trying to use this adjustable overflow drain cover that i purchased to make the water deeper for when I take a bubble bath.. and I can't figure out how or...
  14. JT and the DOG

    Old House - Floor drain, washer basin & new standpipe help

    Hi Folks, I'm a first time poster here, but I have been coming to the site for a couple of years now. My house (in Nebraska) came with a basin for the washing machine drain. See picture #1: That isn't terribly problematic, except that the basin empties into what seems to be a faulty floor...
  15. ChrisNorthNJ

    Vent move for DIY bathroom

    First off - what a great forum this is, I'm lucky to have found it. I imagine this is an easy question for some, but as I'm a DIY homeowner I want to make sure I get some advice. We're renovating a small square bathroom with a small walk in shower. There was a wall separating the side of the...
  16. Jared Pipe & Plumb

    Condensation Drain Connection Part Location

    When connecting the AC condensation drain (PVC pipe) under the sink to the drain I would like to used a brass adapter like in this photo. However I cannot find this part anywhere. I recently starting doing residential plumbing again after years of commercial work, and I used to install these in...
  17. Jian

    Convert single sink to double sinks given narrow stud thickness

    I am remodeling an old bathroom and trying to convert single sink to double sink drains. The old drain system is 1-1/2 inch copper pipe. The stud thickness is 2-3/4 inch instead of the standard 3-1/2 inch. I have read several posts on this forum and is thinking to convert to the design below...
  18. FakeGamerGirl

    Installing standard bathtub in mobile home

    Hello! We bought a flipped house as our first home (yeah we're geniuses) and the tub started peeling pretty quick. We bought a replacement tub that would fit in the space but didn't account for this new tub having an overflow opening when the old one didn't. We also didn't anticipate the trap...
  19. Jon Herrington

    Dirty arm drop! A dance move?

    Good Afternoon everyone! I bought my house in almost exactly 3 years ago today. When I got it inspected, the inspector told me the kitchen sink wasn't plumbed correctly, but it worked so I didnt pay any attention to it. Three years later I want it to work RIGHT. Whenever I use the garage...
  20. tsos93

    What happens if the flange knockout goes down the pipe??

    Hi, I live in the city and I'm remodeling my upstairs bathroom. My flange knockout cap accidentally went down the 4in ASB pipe. How serious of an issue is this? What do I need to do to get it out? I've gotten some mixed answers. I had a plumber come and he scoped it out and found it to be about...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks