Search results

Any idea how I attach the cover plate to the brass trap cover? From the look of it, I should be able to attach with a screw, but the screw hole is not tapped. Is there a trick here to tapping that screw?

This is exactly what I did. I chiseled off the brass cap and vacuumed out the debris. Then I rodded out both sides of the trap while the shower was running. I am replacing the cap after it arrives tomorrow. Thanks for the sane advice!

I found exactly what sixlashes suggested online. It has been installed for five years!!! Sorry for the super late reply.

Is it possible to remove a drum trap from next to a shower without damaging the floor? It is the kind with the lid accessable from the floor. The lid has a recessed square hole. The drain is very slow. I was thinking I could open up the ceiling below and cut/remove the pipe on either side of...

Is there such thing as a customizable Decora switch? I have a set of three switches in a single wide box. They are the old style switches and I'd like to replace them with three Decora style switches. The old switches are each its own contained little switch that is attached to a metal frame...