Search results

Would a couple raps of electric tape be enough to insulate a copper pipe on a galvanized Unistrut with a galvanized clamp to prevent electrolysis of two different metals

I have a hydronic system floor heat my manifolds are fifty feet from the boilers I have a taco 007 pump with a head of 8.5 on the system now. There was a taco 0010 pump with a head of 10.5 the farthest manifold has approximately, 20 ft of 3/4 copper 100 ft of 1 inch plastic, 25 ft of one inch...

Does any one have a good design to get rid of condensate from a building with no drains in northern minnesota?

1 1/4 inch primary 1 inch secondary If the tees where made 5 inches from pipe to pipe instead of center to center will that hurt the performance of the two tees allot? I read 4X the diameter of the primary didn't realize it was center to center.