JasonM
Member
I am planning to replace the 2 old shutoff valves under sink(as shown below) with the quarter turn shut off valve by BassCraft and its supply lines.
May I ask 2 questions regarding this?
1. The 2 shutoff valves are behind the sink drain pipes. Is it usually doable to replace the shutoff valves behind this drain pipe? Just in case the drain pipe needs to be cut out temporarily, where should it be cut for easiest reattachment?
2. Is the copper supply line that I pointed in the photo reusable? If so, how long will it last? I think it is at least 40 years old. Is it better to replace it with this
3/8 in. Compression x 1/2 in. FIP x 36 in. Braided Polymer Faucet Connector
by BrassCraft
Thank you very much.
May I ask 2 questions regarding this?
1. The 2 shutoff valves are behind the sink drain pipes. Is it usually doable to replace the shutoff valves behind this drain pipe? Just in case the drain pipe needs to be cut out temporarily, where should it be cut for easiest reattachment?
2. Is the copper supply line that I pointed in the photo reusable? If so, how long will it last? I think it is at least 40 years old. Is it better to replace it with this
3/8 in. Compression x 1/2 in. FIP x 36 in. Braided Polymer Faucet Connector
by BrassCraft
Thank you very much.