boulder_deb
New Member
- Messages
- 6
- Reaction score
- 0
- Points
- 0
While putting up crown molding, I've managed to nail thru the cold water supply line (to an upstairs bath - not the one being remodeled on the first floor). The hole is through one side of the pipe approximately an inch below the header. It seems that this is going to be a challenging spot to remove the section of the pipe with the hole to replace it. How do you guys deal with this?
Is there any suitable "patch" for long term?
Any advice would be very much appreciated.
Thanks in advance,
Deb
Is there any suitable "patch" for long term?
Any advice would be very much appreciated.
Thanks in advance,
Deb