I just installed a set of wall mount faucets with vessel sinks. The problem is the flow rate is way too high out of the faucets at full throttle and overflows the vessel. Is there some type of washer I can get to put in the aerator section of the faucet to limit the flow? The faucets are bronze so I can't use an add on chrome thing from HD or anything.
In an old showerhead I had something like this. It was basically a flat nylon washer with a small hole in the center.
Anyone know where I can get something like this or other suggestions? Thanks
In an old showerhead I had something like this. It was basically a flat nylon washer with a small hole in the center.
Anyone know where I can get something like this or other suggestions? Thanks