I'm starting to get serious about my bathroom remodel planning. I have decided to replumb the bathroom with Pex-A, and I can borrow a Milwaukee expander from a friend. (shower only, no tub). I have 70psi water pressure. So I am going to install two shower valves with two shower heads, as suggested in this forum. I think I will install 3/4 supply from water heater to the bathroom. Then 1/2 inch from directly below the shower up to the shower valves, and up to the lavatory. Does that sound proper for operating both shower heads at the same time?
Also, is there any specific type of shower valves that I should use in this situation? I want 1 of the shower valves to also supply a tub spout, for filling buckets, ect.... even though there will be no tub.
Thanks for all the help everyone.
Also, is there any specific type of shower valves that I should use in this situation? I want 1 of the shower valves to also supply a tub spout, for filling buckets, ect.... even though there will be no tub.
Thanks for all the help everyone.