softener settings

  1. Sturnbow

    Settings Advice for Softener system Clack WS1 with iron/hardness

    Hi everyone - first timer for this forum and first time owning a house with a water softening system. Just bought a house in Florida with the following from a well water test: Hardness - 9 grains per gallon Iron - 2.0 mg/L Looks like we have a system with a Clack WS1/1.25 controller...
  2. Frieda

    Fleck 5800sxt Cloudy water

    Hello Everyone, With the help of this forum and the immense knowledge gained, I was able to buy a water softener and install it myself! I am getting cloudy water 4/10 times I fill a glass of water. I assume this is still safe to drink as its just salt leaking into the water. I am trying to...
  3. Spencer

    Fleck 5600SXT Settings

    Good Morning, I bought the Fleck 5600 SXT Whole House Water Softener 48,000 Grains Ships Loaded With Resin In Tank, Black I mainly have two questions. 1. My unit doesn’t seem to regen by...
  4. jfzastrow

    Need a bit of help setting up older Fleck Econominder 5600

    I have an older water softener in my home. I believe it's a Fleck Econominder 5600. It's atop a 9x48 resin tank. As far as I can tell it is still fully functioning, I just want to make sure I have it setup to properly regenerate for my household. I recently cleaned out the entirety of the...
  5. CuriousLiam

    Salt Water Softener Drain

    Hi everyone, I recently purchased a Fleck 5600SXT salt water softener and asked a plumber to install it. He installed it in a way that the drain of the water softener leads to our garden. I was wondering if that is gonna cause any problems for the plants? In other words, does the drainage of...
  6. Jason123456

    Fleck 5600 sxt

    The 5600 sxt has not been displaying gallons left and flashes RC----, and I cant seem to get it out of this. The brine tank salt level is a little low, not sure it this would be the culprit. Also I went though the programming and everything seems correct. Ideas? Thanks.
  7. Paddington

    Softener Settings

    Hi..Just wondering if I could get some help with the proper water softener settings for my needs. I just bought a new house that has a water softener installed. Looks like it's a Clack 80,000 grain tank with a Fleck 7000sxt valve. It's a 3,700 sq foot house with 4 full baths. In looking at our...
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks