rough in too short

Hi everyone, I hope all is well! I was hoping to have your guidance on a plumbing related question. It's regarding a floor mounted rear outlet toilet and shifting the rough-in height. I currently have a Briggs 7340 installed (rough-in height of 4 1/4 inches above the floor/slab). The toilet I...

Hello, I am looking at buying a new Kohler toilet, but I have an 11" rough in and I am unsure of what I should be getting because the options are 10" and 12". Could someone please help steer me in the right direction? Thank you.

I am installing 4 Kohler jet heads and the male connections in the wall are about 1/2" too deep to make the connection over the new tile on the wall. I need to extend these fittings out about 1/2" and it would be a disaster to have to pull off the backer board and re-plumb the connections to...

The Toto Aquia II that I bought for my rehab bathroom doesn't fit by 1/2 in (the rough in is 11 1/2). I was hoping I could wiggle it enough, but no go. I could go on about how the contractor did this and I should have skinned him alive, but I still have to fix it. The floor is tiled and ready...