Search results

right, but i'm guessing i should verify first while i'm at it. and i'm guessing there is no way to pull that pipe up?

should i cut the pipe, and drop something down with a string to see if there is water in the pipe? or just move over a few feet and put in a new sand point?

Just replaced a pump, that would lose prime over time, usually overnight. I was always able to prime again though, within a few min. I've replaced the pump, and cannot get it to prime. It just takes water without stopping. This is in northeast Florida, shallow well. No clue how deep it is...

Hello, I have a 5 zone system. All zones are working great except the last one. It will start with normal pressure, and then drop to about 20psi after about 15 min. I've taken apart the valve, no issue that I can see. I've replaced two of the sprinkler heads with lower GPM versions and still...

There is a cleanout in the front of the house. not sure that my snake will reach it though. I'm in jacksonville, just far enough to make it too long of a drive. thanks though.

It’s a horizontal clean out. I’ll have to take a bubble bath to really test it.

Have a disposal, on city sewer. I found a clean out on the outside wall of the kitchen sink. I snaked it with all of my 25 ft snake, pulled back a small amount of hair. It’s a small diameter snake though. No issues anywhere else in the house

thanks for the insight. i did like you said, and i got maybe 1/4 cup of water in the bucket. prob even less. could this be an issue with a clogged vent somehow?

my kitchen is directly below the kids’ bathroom. Almost every time someone takes a bath with a lot of bubbles, it backs up into the kitchen sink. Normal bath with minimal suds or a shower does not cause issues. Any ideas? Thanks Mitch

My snake is 5/16 I believe. Would renting a 1/2 50 ft long be better? My only concern with that is that will it bend past the trap?

Hello all. I have a washing machine in garage that sometimes overflows. I’ve snaked it 25ft snake and that seems to help for awhile. Now the kitchen sink is overflowing when running the dishwasher and the washer is overflowing again. There is about 10 ft between washing machine and kitchen...

Hello. I'm having issues with my pump. My setup well to pump of course. Then on the out side I have a galvanized nipple that switches to ofc to a tank and out to the irrigation. The problem is the pump keeps blowing out where the nipple switches to pvc. My pressure cutoff is at 70. Should...