Search results

  1. LA1

    Need advice replacing a behind tile shower valve for a shower wand.

    I have a shower wand and on/off valve over on the wall 90° and about 3 feet back from where the shower head is. I also have a temp control under the shower head with a main water off and an on/off for the shower.. . It's all made by a company called Barand that has gone out of business. If i do...
  2. LA1

    Electrical Trouble with Bryant furnace

    Had a power surge. Its a Bryant 310A. The fuse was blown FU1 on the PCB, which might be for 24vac?, installed another, applied power and the LED blinked about 3 times and the fuse blew again. disconnected everything from the PCB. Removed the blown fuse and checked across the contacts no short...
  3. LA1

    Water temperature mixer in shower

    See picture below...as of late, when the temp dial is set on hot ( 100° ), half the volume of water comes out as when on cold. Until I discovered this I thought that we were suffering from low water pressure. We also have a hand held sprayer on the other wall that is affected too. The water...
Top