Search results

hey just wondering how tight you go when tightening a steam radiator to the valve....is it normally as tight as possible? or really tight with like a 2 foot wrench? i can put the monster 36" on there and get tighter put dont think its necessary and dont wanna snap something ?

i think it uses a hand held power threader to drive it? ‍♂️photo

its comes down from an elevated radiator!

hi guys So I am preparing to get a mud job for a tile floor and decided I should open a cement patch that was covering a radiator return pipe...good thing I did!!!! t\This thing is heavy rotted ...prolly leaking already ...so I'm gonna either have the section replaced from the union to where...

hey are there an user replaceable parts on the delta rough in valve? I had one installed 10 years ago. the tenant broke off the the little mixing lever on top of the handle. Delta sent me a new one and i was able to screw it in. I was looking at the plastic part of the shower body where that...

thx again guys!

should i get one for the hot water as well?

thanx guys!

got a new washer and when it closes the valve after a rinse or fill i get a very violent bang in the cold water pipe...what can i do?

thanks a lot......from what i can tell the aqua stat is only used for DHW and there is none on the model without the coil. In the summer i turn the boiler off!

weil mcclain eg 50 - natural gas.....i think aqua stat was solely for the coil...i could be wrong

this is a one pipe steam system, cast iron radiators

I have this Honeywell l4006a aquastat on my weil mcclain eg50 boiler.....the boiler used to have a coil for domestic hot water that i am no longer using. The dial is set to 160 and i see a "5" on the differential wheel. Do these settings seem correct for just using this as a heating system now...

so I got this faucet and the pressure is terrible. Is the flow held back by the aerator on this or is there a pressure reducer somewhere?? Anyone know a way I could increase the pressure? I inquired with kohler about a different aerator they said no

even better will do ;)

yes it does, but i checked it after the shower , ill check it before and see if it comes out hot there before the shower

hey guys ... I have been noticing when I take a shower in the morning sometimes the water gets only lukewarm. I am the only one in the house right now. It's a 2 family so I have big water heater a.o. Smith. When I ran the sink after the shower the water was hot. So is it possible the water...

will partially closing the valve lower the heat? I already have the smallest vent on it as it is close to the boiler.

Can I replace a dielectric nipple with a stainless steel one? Will that be ok connected to copper?