Search results

I have the sensitivity set to max, i wanted it to shut off asap after pumping air. I was surprised it shut down at 7.29. It could be that the amps were dropping fast and 7.29 was the last I could see on the meter before the pump shut off. Relative to a blockage, should I be concerned it takes...

I’m just posting this in case someone has the same questions in the future. I ran my pump with the valve open and the system watering normally. The amperage while operating normally ranged from 7.99 to 8.04. I then introduced air into the system to simulate a dry well condition. The amperage...

So if the saver shuts down the pump when I have a dry well, which it does, then why is it not doing it when flow is prevented by closing the valve. Maybe I’m calibrating it wrong? I’d guessed that if the device detected the current drop on the dry well side, it would’ve also detected it on the...

I’m hoping someone with a little better understanding of how a pump saver works can help me out. I’m running an irrigation pump direct with no pressure tank or pressure switch. Basically, I turn it on only to water the yard. I bought a pump saver 233p hoping it might save my pump if anything...