Search results

I just replaced my three control valve manifold with Hunter anti-siphon valves and 25 psi Rainbird Pressure Regulators with Filters (installed directly into the downstream side of the valves). Everything is looking good, except when one of the drip lines with the regulator on it is running...

My tub spout has about a 1/8" to 1/4" gap between the back of it and the tile wall. I unscrewed it today to investigate why, and I think it's just the segment of pipe whoever used to install this is just a bit too long. I've attached a cutaway diagram trying to explain the situation...

I've a very novice DIYer, but trying to make some home improvements were and when I can. Thinking about putting in a new faucet and stopper for the bathroom sink, I discovered what looks to be plumbers putty around the compression nut on the p-trap. There's no leak, but this doesn't look right...