Search results

A2 sorry I didn't hijack anything I didn;t know there was anA / a2 version dont be a jerk

if I get the exhaust vent collar kit like on the 240A2 will that work to clear the error and can I do that myself by lifting out the pipe or does that collar kit need to be redrilled and attached to the 210A top?

is this on the 210A or A2?

sorry

sorry

is it the thermistor I need to replace and is it possible?

its pushed all the way down but inside 2" down the pvc is a 2 screw port with a blue 2 wire labeled exhaust with a connector clip to a pack of wires that it's cut out from.is that the sensor and can I replace it?

thanks for the reply - the E515 was there pre pcb swap,I can try the collar but the top doesn't have the newer collar Ive been seeing that the newer ones come with.It's flush with the unit but I think there enough play in the exit pvc out of the wall

there's light coating of carbon on the flame rods about 1/2 way on all the rods so I ordered some new,should theyjust pull off with the boots along with wire for sensor?

Hi GR thnx for rply,indoor 2015 npe-210A no venting messed,I did see the fix as being not enough length going into top but does this unit need that special collar with the sensor?can I undo the hose clamp and shove the pipe father down as this would make the exit pipe uneven,I also want to check...

Hi brepleum,swapped the board shows E762

Thanks so much I'm gonna do this tomorrow afternoon

what about the DIP settings? i just got an estimate for 380.00 from 2 different plumbers so I have no experience with this but the DIP settings sheet needs to be followed or is the old board DIP settings applied?thanks alot...Ken

Hi Art,I just ordered the same pcb for the same unit 210A and wanted to know if this is a plug and play or do I need to do anything to get the other board to work after restart power...thanks alot,Ken

Hi Art,thanks for the great stuff-I just ordered a board per your post and am hoping to exchange it piece for piece so is there any need for some kind of restart steps or is this a plug and play?...Ken