Search results

That’s correct. That’s the pipe sloping the wrong way. I can cut out that elbow for sure. I don’t think I can raise that end because the vertical pipe coming out of the wye into the cast iron would block me. Do you think I’m overcomplicating this? Perhaps I can cut that stub going into the...

Hey Everyone - Hoping to get some advice on properly reconfiguring this gem the previous homeowner left me with. You can see how bad it pitches the wrong way. I called a plumber, but was quoted $1,800 and I don't have that kind of money for this repair, so I'm hoping to get this done myself...

You did not misunderstand. I just did a poor job of putting it all together/explaining. But I understand what you’re saying now. Ideally they should all be at the same height. Right now, the way it was installed originally, lav 1 was lower than the other 2. When I said it needed to be raised...

Makes sense. I gave it a shot to sketch out what this may look like. Am I remotely close?

Thanks Wayne. I’ve had a crash course in plumbing the last week trying to make sure this is done correctly. After thinking about it, I’d like to do the single revent, but it may be easier to do the 3 revents as long as that’s up to code. Reason being is the far right drain (labeled master lav...

Thanks Wayne. This is extremely helpful. The way it’s currently done (first pic) I should have mentioned that horizontal drain is currently 2”. The first pic does not show the 3rd sink. I forgot to include that. That one is probably 12” closer to the vent (to the left of the left sink). It is...

I’m getting two bathrooms remodeled and now that we’re up to installing fixtures it’s hitting me it doesn’t look quite right. Hoping to get some advice before I talk to the contractor. Tried to do my best with a diagram and some pictures, but unfortunately the walls are closed up. It’s a...

Thanks for the quick reply. I attached a couple pictures. They're not the best. I can take another when I get home from work if it'd be helpful. One is of when I had the wall open (kicking myself for not dealing with this then), the other is how it is configured now. Behind all that spray...

I'm in the middle of re-doing the waste line in my crawlspace, and I'm also re-configuring the waste line for my sink as part of a kitchen remodel. I'm hoping to get some advice as to what my options are. I attached a drawing (I apologize ahead of time, I'm obviously no artist). The kitchen...