Search results

https://www.grohe.us/contact-us Take a pic send it in

600 wog full port name brand. Biggest problem with any brand they need to excirsise ( open and closed)at least one a year.

Call Delta would think with their commercial and industrial line they might have something.1-800-345-DELTA (3358)

Three switches? What them to over ride the switches? 2 wire and a neutral motion lights? They make 4 way motion sensors.

What do you have between all three legs? Between all three to ground? What are you looking for? 120 vac? And amps?

Have a slice of bread or two? Smash the bread like your making a snake out of clay jam into the pipe and soldier it. When your done after it cools water pressure will push it out. A drop of water will screw up a joint.

What brand is the air device ( micro bubbler)?

If your looking for a contractor start here. Might also look up laborer 205 251 8810 That's more that a third of a mile. Crossing a creek might be a big deal with permits. Looked into a well?

Buried pvc along with 26" of expansion @20° difference in temp needs expansion joints and ASTM D2774 what is needed for back fill. Pressure drop ( head) almost quadruples doubling the flow from 10 to 20 gpm. Might want to look into High-density polyethylene pipe (HDPE) can get it in a 2000' roll...

There is no other wires running with the wires from disconnect to dock? Have a drop light with incandescent bulb? Tie a couple of pieces of scrap wire on plug put it across hot and neutral and check voltage between coming from plug to neutral. Also check connection at ground rod.

No, don't know Florida code might just need a double check or a vacuum breaker. Need to check with your water company or plumbing inspector.

Check the plug in on the board might a have a pin out of place.

start by removing the access panel cover and insulation. Locate the red reset button that is typically above the thermostat and press and hold it until you hear a click

Could be the mixing valve opening and closing..Have you cleaned the heater with vinegar? If it's been a while might want to use a commercial cleaner. Here a service manual page 47...

Brand and model number of new heater. If its condensing w heater has to be pvc all the way out. Install.manual will have what the manufacturer wants.

2" pvc coupling o.d. is 2 11/16 - 2.688 2.5 coupling i.d. 2 7/8 - 2.875 .187" difference Think I'd go back with a 2" pvc cutter and cut the st 90° flush with coupling and cut the pipe out same with the other two...

Sounds like a 1/4" of play? That's alot of play. Shaft up and down any play? A couple of thousands is to much. Also pull the blade and clean it doesn't take much to knock it out of balance. When you clean the outside unit coil ever pull the top and split the coil if there is two coils?

https://www.tuhorse.us/pump-sleeves/?srsltid=AfmBOoojnGuuJMSeeBxvr1SECNePB7ciiYAjPTKBo9CmS_6w-Lgj9Qvs

If TDS is that high a softener would help. A piping change might also help. Pipe cold water in the bottom then the inlet is lower than the dip tube unless heater is a self cleaning. Mineral deposits don't all stop in the tank they stay in suspension and travel through the whole piping system...

Theres just three wires two hots and a ground. Two hot doesn't matter with the two hots which one goes to which hot. There are two thermostats on under each cover. Elements work like this. Top comes one first when it is satisfied sends power to lower when it satisfy sends power up to top...