Search results

The KL tank is black so can't check expansion. I have a vent/pipe on the 1" drain pipe from the water treatment system to prevent act as an air gap. Actually it is a fitting connected to a pipe on the elbow of the drain where it connects to the house's main drain. It was the only place to...

Greetings All, I have a Fleck 5810 SXT valve on my Katalox Lght tank. It developed the dreaded 5810 drain leak a year ago. I replaced the Fleck 61924 Cartridge Seals and Spacers, reused the old yellow piston and smeared a lot of Molykote No 7 grease in the bore, piston and spacer. The leak...

Hi All, I have a Atlas Hydra 90 micron backwashing pre filter. https://us.atlasfiltri.com/product/hydra-self-cleaning-stainless-steel-90m-cartridge-1-npt I was backwashing once a week or two into a bucket for years but when our well started having issues and we were forced to backwash after...

Long overdue update: After using the above sanitizing procedure with no change, had the well successfully redeveloped although they got a little black sand and gray clay out. Fingers crossed. Also determined that 21 year old well pump's check valve was bad and had that replaced. After...

I run it on my long asphalt driveway to give the chlorine time to dissipate/evaporate so if wildlife drinks from a puddle they should be ok. My driveway is now heavily stained from the raw water/iron and mineral content. Glad I didn't seal the driveway at the beginning of the summer like I...

Hi, The first pic was the sample taken from the pressure tank with the spigot cracked on 8/22. The second pic is it 2 days later. We are still getting crude in our Atlas Hydra 90 micron after well pump kicks on, We received some rain last week and thought the clogging was getting a little...

The dish is actually a bucket and the slime floating in the water was on the bottom of my 4x20 pleated filter. This stuff is like grease and not easily removed. The mud colored stuff on the spin down filter cartridge (yellow) is not really a gel, just a thick coating of whatever and not...

Hello All, I have some knowledge of water treatment but not as much as most of you, and what knowledge I have gained is from the 6 years of managing this system, from this forum and consulting Dittohead. 6 year old System: Output to input: Softener (Fleck 5810 SXT 1.5 cu ft. 10x54)...

Hi Reach, You've brought up concerns that I never thought about. When scaling for this system back in 2017, I checked gpm at the pressure tank, before any other filtration and If memory serves me correctly, we got very close to 10 GPM. Now that we've added an Altas Hydra 90 micron spin down...

Pic

Hello All, I have some knowledge of water treatment but not as much as most of you, and what knowledge I have gained is from the 6 years of managing this system, from this forum and consulting Dittohead. 6 year old System: Output to input: Softener (Fleck 5810 SXT 1.5 cu ft. 10x54)...

Double Post

Hello All, What water testing labs are you guys using nowadays to test your well water? Has anyone used SimpleWater, TapScore? https://mytapscore.com/collections TapScore seems to be the cheapest and includes shipping in both directions. I'd prefer to use a local lab here in Maryland but...

Thanks all for your help and advice.

The UV is last (last piece of equipment before faucets) or downstream of softener -> KL ->Neutralizer. My understanding is KL filters down to 3 microns so unless softener is seriously increasing mineral size, wouldn't UV light be OK? . Sediment filters were installed to protect water...

What micron level do you folks typically recommend to protect water treatment valves - neutralizer, KL, softener, UV from sediment and other nasties? Currently using a 90 micron Atlas Hydra spin down followed by a 4x20 Big Blue with a 20 micron non- cellulose filter. Any reason to filter below...

My well is 237'. Very, very infrequent H2S small since water treatment system was installed.

My mistake. My sediment filter is Cellulose-free synthetic filter media. I assume that is OK to use in non-chlorinated water? Is sanitizing/disinfecting cold vs. hot water or vice versa more important? I focused on the cold water side. Thanks...

Thanks all for the replies, suggestions and info. I ran about 1 to 2 cups of bleach in my Atlas Hydra Spin down filter to sanitize plumbing with all treatment devices in front of it in bypass. Hopefully it didn't compromise my 20 micron paper filter in front of it. I did tap on my neutralizer...

I have an almond neutralizer tank that I can shine a light through and also a fill port. After 3 + years, the calcium carbonate level is not quite 1/4" lower than when it was shipped and installed. I have never opened the fill port or tapped on the tank while it is regening to see if it is a...