Search results

Similar situation...what did you guys end up doing? thx

Hello, Was wondering if you could connect with a tee fitting multiple systems into one 1/2" backwashing line...line goes out to dedicated leach field. This would be the easiest to accomplished without running additional lines through the concrete...maybe use check valves on each line? Thoughts...

thank you, i agree. Thats why i wanted to reach out on this forum, appreciate all of your advice!

Thanks for your in-depth reply...great information, thank you. I spoke to the water treatment company they had suggested: Anion > Acid Neutralizer (since the anion lowers the pH) > Water softener. But the water treatment company is a little concerned that in this order the maganese (0.30...

Great Info- thank you....here are more details...please let me know your thoughts: - Raw untreated Incoming pH=6.35 - Hardness 8.6 grains - Anion Resin= SBG2 (chloride form type 2 gel strong base anion resin) The current calcite acid neutralizer brings the pH from 6.35 to 8. And increases the...

How much does the Anion treatment lower the pH?

Hello, Looking for some advice on the orientation/order to put the filters in: Anion Treatment, Acid Neutralizer, Water Softener. Incoming Raw Water Test - 6.35 pH - 0.30 Maganese - 8.6 grains Hardness - 0.90 Uranium - No Iron I am trying to figure out the order of to put the filters in. Was...

Hello, Please see the attached pic. How does this look for IPC? Lots of obstructions in the basement and this is the best i could come up with. Ideally i would like to wet vent the lav, shower and WC and then connect the laundry after the group. If i dry vent everything individually (vents not...

thanks wwhitney, i read a lot of your posts...you are a legend

Hello, Plumbing a bathroom group that consists of a toilet, shower, and lav. The drain for the Lav is 2" and serves as a wet vent for the shower and the toilet (3"). Can the dry vent coming off the top of the sanitary tee of the lav be 1.5"? or Does it have to be 2"? I have some limatations in...

Thank you for the help!

Hi All, What type of tool do you use to install this type of plug? I noticed there is a brass threaded insert....not sure what that is used for.... Thanks!!

In the attached picture is a stub out for a bathroom lav. To get to the desired stub out height a turned 90 and a street 45 were used. The vent is about 3' from the p-trap. I am wondering if using the 90 and 45 to get the desired stub out height is against code? The piping is 1-1/2"abs, the vent...

Thanks everyone for the input. The sink will have a disposal and undermount sink on it so I roughed it a little bit low.

Hi All, How does this look for a bar sink? 2" drain downsized to 1.5" where it comes through the wall. The vent is 1.5" connected to the 2" pipe with a sanitary tee . Long Turn for the elbow. Just want to make sure everything is done correctly. Drain rough at 14.5" from the floor. Thanks in...

Thanks Terry!!

Hello, I just want to confirm if the use of this Sanitary Tee is correct. The 3" Vertical stack going up is *NOT A VENT* and is the waste line for a Bathroom group (Tub, Lav, Toilet). The 2" horizontal pipe is for a bar sink that is vented just after the p-trap. Is the use of a sanitary tee in...