Search results

Thanks

this is a site in Maine using UPC

can the washer 2" line discharge before the toilet. Someone posted elsewhere it must connect after the toilet waste connection can't find anything in the code.

it can be done but certain distance to window or door are required

I was thinking of connecting that 2" pipe with lav shower and wash in vertical going down to sewer downstream of toilet, that work?

Update rev2 Run 2" off lav tying in Wash and vent run shower into that Run tub into end of 3" x 3" x 2" PVC DWV 90° Elbow

thanks so one dry vent off the lav takes care of of everything except toilet? Wat about the tub? Just so you understand why i said shower was 1.5" I read it here

this is a cabin in Maine, they follow UPC Shower and bath 1.5" lav 1 1/4" The cabin sits 30" off the ground so access is ok. A septic system is being installed The toilet will connect to 4" vertical then to septic. Thinking to run 2" wash into 4" vertical stack, can the other fixtures tye into...

this is in Maine they use UPC 2", so I need to add above and or below to make up for it.

So how can I get a shower drain to fit in the 2x6 space, must be a way

putting bath room second floor floor with joist 2x6 can these be used to be code compliant?

Doing a 2nd fl bath, shower sink toilet, washer not sure so I indicated option one and option two rafters run parallel to wall Can a 2" washer go into the 2" shower as in option one? trying to do one vent off sink

planning to add a toilet and shower, the joists are 2x6 or 5 1/2". Is this enough space to run the trap for the shower and bend for toilet?

yes they would be

I have an issue with the main sewer line being below the septic tank if it comes out under the sill plate. This is a cabin on pier foundation. The design engineer wants it to exit about 12" higher, he suggested simply making 3" hole out the side of the cabin wall above the floor. Is that...

New cabin on lake just two people, trying to get suggestions on pumping the lift is about 12' above the lake .just summer time use so no freezing issues Should I draw water in a holding tank, then pump it into house? Or a pump directly from the lake with this type having built with a small...

I have a 2" street feed, this is a warehouse 250' long to supply 8 half baths. 1. I was thinking running 125' 1.5" then 1" as the main which would tee off to each bath room 2. Or can 1" all the way handle the flow? 3. what kind of pipe Pvc I was thinking Street psi is 70

Building new home the builder typically uses 1/2" cpvc for single shower (no tub) he wanted a small fortune to upgrade to the addition of rain fall & 3 massage sprays. I think 1/2" is rated at about 14gpm, granted not all will be on at the same time, is 1/2" adequate? I asked him to just...

Terry I don't have the pic of that but assuming for moment it is. can a claw foot tub drain be plumbed into that waste pipe above the slab

it's vented just not in pic, can it be connected?