Re: Copper size for bathroom
Posted by Sylvan TiegerLMP on December 29, 2003 at 16:01:39:
In response to Re: Copper size for bathroom
: I am tapping into 3/4" copper to plumb a new bath. What are guidelines for when I can drop to 1/2" pipe? Is there a length vs. GPM for each size? I am most concerned about shower/bathtub combo as I want adequate pressure. The single sink I am sure would be fine with 5' of 1/2".

: What is standard shower head GPM?

: Thanks!
: Jim


Jim your not going to increase pressure by increasing pipe size JUST the volume will change GO 3/4 both hot and cold



Replies to this post
There are none.