|Posted by Steve on October 26, 2001 at 16:01:16:|
I have an old oil funace in my detatched garage, that I use to keep the garage warm while I work out there. When I tried to start it last week, I couldn't get a flame. It is getting fuel, and the igniter will spark when I short out the high volt terminals. I have a feeling that the electrodes need to be adjusted, but I don,t know where to start. (This is an old residential, down draft furnace) Any one know what the position of the two electrodes should be, relative to the nozzle?
|Replies to this post|
|There are none.|