Re: underground copper pipe

Posted by dale's plumbing service on March 28, 1999 at 18:32:59:
In response to Re: underground copper pipe
: Mike:--Type "L" copper should get the job done, and any type of joint will be accepable if it is accessible. If not a soldered joint will be good. : Bud.... dale's plumbing service, bud is right,but i would use 1" sch 80 and i will bet it will out last any copper,but again it depends on what your water has in it.if you have had pin hole problems i would go plastic,but thats only my opinion. try useing 1-14" instead of 1".Dale

Posted by dale's plumbing service on March 28, 1999 at 18:32:59:

In response to Re: underground copper pipe

: Mike:--Type "L" copper should get the job done, and any type of joint will be accepable if it is accessible. If not a soldered joint will be good.
: Bud....

dale's plumbing service,
bud is right,but i would use 1" sch 80 and i will bet it will out last any copper,but again it depends on what your water has in it.if you have had pin hole problems i would go plastic,but thats only my opinion. try useing 1-14" instead of 1".Dale

Replies to this post

There are none.