| Posted by Mark on February 05, 19101 at 11:34:47: | |
|---|---|
|
When I moved in to my home, the dishwasher had a 3/8 od water supply line and a 1/2 inch copper drain thru the floor down to the basement. It didn't go to a disposal because the dishwasher is not next to the sink. Now this 1/2 inch drain is slow draining. The drain is too narrow for a snake and must have a clog at or near either of the two or three 90 degree bends. It goes thru some finished areas of the basement, so I hate to break into the drywall. Can the line be blown out with air pressure? Or, should I bite the bullet and install a 3/4 or larger pvc drain instead. Thanks for your ideas. Mark |
|
| Replies to this post |
|