shower handle

I have a Delta 13/14 Series faucet installed in 2011 and need to replace the cartridge but I'm unable to remove the handle cover. The only screw is under a cap on the end which I removed and loosened but the cover over the cartridge is stuck. I don't want to use too much force to remove it or...

Hi there! We purchased a new home about a month ago and I noticed a leak in the ceiling coming from the master bath area. We hired Oliver Plumbing to come out and the person suggested we just re-caulk the shower/steam shower... 190 dollars later and no real help... I did this and it obviously...

I am trying to replace my shower handle and I can 't quite figure out how to remove the old handle. I have removed the lever and the escutcheon, but cannot get the rest off. I can't find any screws or anything on the handle, and I am wondering if anyone knows how to remove? Any input is appreciated!

Hi Folks, My shower handle has come loose and I know I simply need to tighten the screw, however I can't work out how to access the top of the screw. Does anyone know how the do that to the type depicted?

I have a Moen shower handle (unknown model) that doesn't seem to have a set screw. Before I go yanking on the handle, any thoughts on how to take this piece off?

Made some photos: https://imgur.com/a/mbW1EiK It looks like there is a space where the set screw would be, but there's nothing on the inside I rotate the whole way it allows and looked in with a flash light, and also tried to "feel" it with a screw driver, but it never latches. I then noticed...

Hey everyone, I've scoured the forums here but haven't been able to find an answer. I have a Glacier Bay single handle shower set. I need to replace the shower cartridge. I went to unscrew the set screw and it was stuck. I put a little muscle to it and the extra torque just twisted it off...

This is my first post for any kind of DIY so i hope i put all the info needed in here. The shower knob is NOT turning off the water in the shower now (so i turned the water off to the whole house). i am in a Lennar home (shitty builder) and they stripped the screw they put in the shower knob...

Hello. Just started getting a drip leak and the one shower handle is loose. It won't turn the water on/off. No evidence of screw holes or any other holes. If I push in the knob, the other handle moves in also. Tried pulling/twisting/turning on the cap but it's not budging and I didn't...

A while back a plumber moved the valve and the water only gets lukewarm, if that. I'm trying to remove the handle to get to the valve but there doesn't seem to be a set screw, and if there is my hex wrenches aren't doing anything. How do i remove it? In the image it may look like there are 2...

Hello All, Any help that could be provided would be much appreciated. I live in house built in the early 50's ('55 i believe) in Northern Virginia. I was trying to replace the seat and stem set-up in the bathroom, and I was told I would need American Standard hardware, I ordered from a...

I'm on the final steps of the bathroom remodel. Who would think that getting a replacement handle/trim kit would be such a task! In any event, I was able to identify my valve as a "PF" or pfister shower facet valve. However, the suppliers are telling me that no handle/trim kit is...

don't see a set screw anywhere, but could it be possible the shower actually needs to be turn on to see it? This could be 1980 vintage, up and down for volume, left and right for hot/cold. won't turn off without a lot of luck. thx

Hi All: I am trying to replace the cartridge in c. 1994 shower faucet handle as pictured. Question: I removed the center screw at the bottom of the handle but the handle won't budge. Is there another screw hidden somewhere. (I tried prying the handle off in case it was stuck from hard water...