removal

Hi All, I am trying to resolve a partial blockage in my main outlet to my septic tank. The lowest point drain is my washing machine drain right next to the main outlet. It occasionally backs up when there are multiple draining activities along with the washer draining. In any event, I want to...

Hello, I would like to remove a standalone bidet (see attached photos) and cap/terminate both the water supply lines as well as the drain line. We're converting to a washlet and will be installing a linen cabinet in place of the bidet. Opening up the wall isn't an issue. Water supply lines...

I'm removing an interior wall above a finished basement. The supply lines for an old laundry there run to the outside wall along the floor joist where it T-s. I cut a hole in the floor to access. The 1.5" waste pipe runs with the supply lines, only it elbows and runs straight down the outside...

I have a Pegasus fixture that I can't get the handle off. I have removed the set screw, sprayed with lime-away, WD-40 and tapped wood wedges behind the handle to no avail. Am I missing something? I hate to force it too much and break something. Any suggestions would be appreciated. Thanks!

Hey all, Our well water was acidic with high nitrates so I installed an acid neutralizer, and water softener with a mix of softener resin and nitrate specific removal resin. In this order; pressure tank -> 3 stage big blue filters --> acid neutralizer --> water softener (mix of softener resin...

Hi ... Just bought this new house and looking to remove a low flowing worn out Grohe kitchen faucet The faucet body is held down to the counter with a U shaped clip , I don't see a nut that locks against the clip holding it up , It seems to be threaded on and It doesn't look like it could be...

I have to install a new kitchen faucet in a tight space but cannot do so without temporarily removing an existing Insinkerator 500 garbage disposal. Will this removal and reattachment be relatively easy to do or present possible difficulties. Thanks for your help!

Can someone help me. How do I get this tub spout off. I have tried everything but the hand of God and cannot figure it out. I am assuming th is is an original spout so maybe 1959. No set screw. I cut off the end to get a look inside but I'm still stumped. Please help, I've got to get these...

We just had a wall removed that was perpendicular to this soffit? ( not sure what it’s called) this soffit is parrealel to the ceiling joists. I know that normally means it isn’t load bearing but I just want to make sure. Also I just want to level it out with dining room ceiling. I exposed the...

I'm in a bit of a bind with my current plumbing setup. My townhouse (NJ) is built on slab and all my major HVAC/water appliances are sitting in a small laundry room on the ground floor level (see the image). Now came the time to replace my furnace but it’s completely blocked by the pipes coming...

I'm having problems with root intrusion into a sewer pipe. A few years back a clean out was installed, and I realize now it wasn't sealed properly, because the roots are growing in right at the joint of the clean out and the sewer line. I can see the root hairs from the clean out, and I've been...

hi... i removed the subfloor around the flange (improper floor install) and now i want to remove the old flange. i'm confused as to what i have exactly. it looks like something is attached to the cast iron pipe. is that some sort of riser? do i remove just the flange or the entire piece...