reducer

How do you prevent a 4 inch cast iron soil vent that reduces to 1-1/2" from collecting debris (leaves/sticks/etc)? See photo. This photo is not mine, but I have the same setup. I believe this meets code in NY from a frost perspective. Before i shop vac this thing, I would to find a...

I cannot identify this type of thread. BSPP, NPSM, NPSC?? Something else? I count 2 threads more than NPT, and seemingly shallower valleys. Diameter is 1-1/4". I need to adapt to either a 1/2" NPT or a 1/2" sweat.

Just bought a new clothes washer, and it says to connect the waste to a minimum 2" pipe, my house has 1.5" pipe so I followed it to this, pictured below. Is that a reducer? can I just hack that out and replace it with 2" pipe?

Hello, I am looking for an honest advice and I hope I can get it here. I am replacing a 40+ years old tub in my bathroom, I live in a condo so the floor is concrete. The tub drain pipe is located above the concrete and is Brass 1.1/2" I guess. The shower base that I bought is a Shower pan...

Good Morning! I'm new here, just joined and searched for this question and was unable to find the answer. Can you turn a Wye on its Y, for lack of a better term? For those that like to read, I explained a lot below the photos. For those who don't look at the photo and tell me if it is a- okay...

Hello. I recently bought a house that has an outdoor spigot that I am having difficulty connecting my garden hose to. The spigot has a 1.16" opening and I can't find a reducer to connect my 3/8" garden hose to it. I have attached an image in this post. My house is in the Dallas region built in...

I had a broken toilet flange. I cut off the old lead drain pipe, leaving a 1.5" stub before the cast iron fitting. How should I connect the new PVC pipe? I tried to link pics of the possible solutions. Use a shielded 4" Fernco coupling to a PVC 4" to 3" reducer, then 3" PVC pipe...