plug

Hey everybody-- I have a floor drain whose cleanout threads are bad, so that the existing 1.5" NPT PVC cleanout plug won't thread back in. Maximum OD of the plug's threads is 1.89", so it must be 1.5" nominal NPT. I'm having an awful time knowing for sure that I'm finding the right rubber...

Hi All, I am trying to resolve a partial blockage in my main outlet to my septic tank. The lowest point drain is my washing machine drain right next to the main outlet. It occasionally backs up when there are multiple draining activities along with the washer draining. In any event, I want to...

So, I installed a RO drinking water system yesterday under my sink. I did drill a 1/4” each hole in the drain pipe, and used a saddle to connect the RO drain rubbing. This all works fine. But I realized I connected the saddle AFTER the p-trap, where it should probably be before. So now I’m...

On my list of things to do from the inspector was to test my drain lines. I have plugged my shower drain, toilet, kitchen, and bathroom sink with mechanical wingnut test plugs. The outside clean out will be plugged with an inflatable rubber test ball plug. I will then fill the lines with water...